研究者詳細 - 長谷川　泰久

講演・口頭発表等 - 長谷川　泰久

分割表示 535 件中 461 - 480 件目／全件表示 >>

外骨格型上肢作業支援システムの研究開発 -上肢麻痺患者の足操作による卓上作業支援の実現-

日本機械学会ロボティクス・メカトロニクス講演会2009 2009年

PDAC-based Underactuated 3D Bipedal Walking –Stabilization of PDAC Constants and Walking Direction Control-

IEEEProc. of the 2009 IEEE International Conference on Robotics and Automation 2009年

Transition Motion from Ladder Climbing to Brachiation for Multi-Locomotion Robot

Zhiguo Lu, Hironari Yoneda, Kosuke Sekiyama, Toshio Fukuda, Yasuhisa Hasegawa

2009 IEEE INTERNATIONAL CONFERENCE ON MECHATRONICS AND AUTOMATION, VOLS 1-7, CONFERENCE PROCEEDINGS 2009年 IEEE

開催年月日： 2009年

記述言語：英語会議種別：口頭発表（一般）

This paper describes a transition motion from ladder climbing to brachiation for the multi-locomotion robot (MLR). Though the transition motion is as complicated as human doing, the robot shoulder degrees of freedom (only 2 DOFs) are less than human. The paper presents how to make the robot complete complicated motion with limited freedoms. In order to prevent the motors overload, a soft adaption control which can change its style automatically according to the contact situation is used in the turning waist motion for error adjustment. Experimental results show that the MLR realize the transition motion from ladder climbing to brachiation stably and smoothly.

researchmap

装着型指動作教示システムの研究開発

計測自動制御学会第10回計測自動制御学会システムインテグレーション部門講演会 2009年

２足歩行における人とシステムの協調制御

日本機械学会福祉工学シンポジウム2009 2009年

装着型歩行支援システムの制御を目的とした指装着型コントローラの研究開発

計測自動制御学会第10回計測自動制御学会システムインテグレーション部門講演会 2009年

Analysis of Relationship between Limb Length and Joint Load in Quadruped Walking on the slope

Tadayoshi Aoyama, Kosuke Sekiyama, Yasuhisa Hasegawa, Toshio Fukuda

2008 IEEE/RSJ INTERNATIONAL CONFERENCE ON ROBOTS AND INTELLIGENT SYSTEMS, VOLS 1-3, CONFERENCE PROCEEDINGS 2008年 IEEE

開催年月日： 2008年

記述言語：英語会議種別：口頭発表（一般）

An animal has a characteristic ratio of forefoot and rear legs so that its morphology can adapt to the living environment. Likewise, the structure of robot should be better fitted the locomotion in the working environment. This paper derives an optimal structure of the quadruped robot, which minimizes the sum of joint torques of the robot. Minimization of the joint torque allows to reduce the joint acceleration in walking motion, and hence to reduce energy consumption. Numerical simulation analyzed joint torques in each limb length and slope angle under walking on a slope. The optimal rate of rear leg length (RRL) is derived by the simulation as the physical structure. Our analysis suggests that the joint torque will increase as the slope angle becomes steeper in the case that the rear legs are shorter than forelegs. On the other hand, the joint torque will decrease as the slope angle is declined in the case that the forelegs am shorter than the rear legs. Experimental results validated the simulation analysis.

researchmap

Five-fingered assistive hand with mechanical compliance of human finger

Yasuhisa Hasegawa, Yasuyuki Mikami, Kosuke Watanabe, Yoshiyuki Sankai

2008 IEEE INTERNATIONAL CONFERENCE ON ROBOTICS AND AUTOMATION, VOLS 1-9 2008年 IEEE

開催年月日： 2008年

記述言語：英語会議種別：口頭発表（一般）

This paper introduces an exoskeleton assistive hand that supports human hand and wrist activities by using user's bioelectric potential to control the exoskeleton movement. The exoskeleton has three active joints for an index finger, three active joints for combination of a middle finger, a ring finger and a little finger and two active joints for a thumb. It also has two passive joints between the index finger part and the combined part of the three fingers. Our proposed poly-articular tendon drive mechanism simulates a mechanical compliance of a human finger so that the exoskeleton could realize comfortable and stable grasping. This paper proposes a new mechanism "dual sensing system" and a new control algorithm "bioelectric potential-based switching control" so that the exoskeleton could synchronize wearer's hand activities without any force sensor. A tendon-driven mechanism and a dual sensing system enable wearer's fingers to move freely when they does need power assist but precise position control or force control. A bioelectric potential-based switching control enables the exoskeleton to augment their grasping force only when wearer's fingers generate a relatively large grasping force. A five-parallel-link mechanism is used to assist wrist activities of a wearer. Through experiments it is confirmed that the exoskeleton does not disturb a wear's pinch of a small object and that it augments grasping force for a heavy work.

researchmap

PDAC Constant に基づく3 次元動歩行の安定化

日本ロボット学会第26回日本ロボット学会学術講演会 2008年

Vertical Ladder Climbing Motion with Posture Control for Multi-Locomotion Robot

Hironari Yoneda, Kosuke Sekiyama, Yasuhisa Hasegawa, Toshio Fukuda

2008 IEEE/RSJ INTERNATIONAL CONFERENCE ON ROBOTS AND INTELLIGENT SYSTEMS, VOLS 1-3, CONFERENCE PROCEEDINGS 2008年 IEEE

開催年月日： 2008年

記述言語：英語会議種別：口頭発表（一般）

This paper introduces a vertical ladder climbing of the humanoid robot only by the posture control without any external sensors. The humanoid robot does not have any special structure for fixing the body to the ladder. The robot maintains the body on the ladder by its grippers like human does. As a problem of this locomotion, a free gripper position of the climbing robot is not controllable because a yawing of the robot body around the axis connecting a supporting gripper and foot on the ladder is not fixed. To solve this problem, the momentum around AOY caused by the gravity is used to control the yaw motion of the body so that the various gait such as pace gait and trot gait could be realized in a ladder climbing maneuver. The algorithm of ladder climbing with recovery motion is experimentally verified by using "Multi-Locomotion Robot(MLR)" which is developed to achieve various types of locomotion such as biped, quadruped walking and brachiation.

researchmap

多関節腱駆動機構による指先剛性制御

日本機械学会ロボティクス・メカトロニクス講演会2008 2008年

外骨格型手作業支援システム

日本機械学会ロボティクス・メカトロニクス講演会2008 2008年

Finger Stiffness Control Using Poly-articular Tendon Drive

SOFTProc. of Joint 4th International Conference on Soft Computing and Intelligent Systems and 9th International Symposium on advanced Intelligent Systems 2008年

傾斜面上の4足歩行における脚のリンク長の比率と関節負荷の関係

日本機械学会ロボティクス・メカトロニクス講演会2008 2008年

倒立振子モデルに基づく2 足歩行軌道生成に関する考察

日本ロボット学会第26回日本ロボット学会学術講演会 2008年

マルチロコモーションロボットの角運動量考慮による垂直梯子登り動作

日本ロボット学会第26回日本ロボット学会学術講演会 2008年

Wearable Handling Support System for Paralyzed Patient

Yasuhisa Hasegawa, Yasuyuki Mikami, Kosuke Watanabe, Zeinab Firouzimehr, Yoshiyuki Sankai

2008 IEEE/RSJ INTERNATIONAL CONFERENCE ON ROBOTS AND INTELLIGENT SYSTEMS, VOLS 1-3, CONFERENCE PROCEEDINGS 2008年 IEEE

開催年月日： 2008年

記述言語：英語会議種別：口頭発表（一般）

This paper introduces a new wearable handling support system for a person who has trouble in motor capability of his or her upper limb. The support system is used as not only a support system to make his upper limb active in daily life but also a rehabilitation system to reduce manual loads of physical therapists. The system measures three rotation angles of patient's head: pitch, roll and yaw to control three degrees of freedom of the support system; angle of elbow joint, angle of wrist joint and hand close/open, respectively. Hemiplegia patient who has paralysis of one half of the patient body can use both arms cooperatively by wearing the handling support system on the paralysis side. In our experiments, the system helps pouring task from POP bottle to a glass, while an upper limb on paralysis side of a user grasps the POP bottle and the other upper limb grasps the glass.

researchmap

腱駆動型把持支援システム

日本ロボット工業会第11回建設ロボットシンポジウム 2008年

重力モーメント考慮の姿勢制御によるマルチロコモーションロボットを用いての垂直梯子登り運動

日本機械学会ロボティクス・メカトロニクス講演会2008 2008年

レーザーレンジファインダを用いた上り斜面認識に基づく歩行遷移

関山浩介, 古城美貴子, 青山忠義, 長谷川泰久, 福田敏男

日本ロボット学会学術講演会予稿集(CD-ROM) 2007年9月13日

　前のページ - 次のページ　

<長谷川 泰久>

講演・口頭発表等 - 長谷川 泰久

<長谷川　泰久>

講演・口頭発表等 - 長谷川　泰久